Innovv PowerHub 1
Wires and connection
Ignition trigger- yellow wire (145cm/57”)- connect to a switched power source like head light, trial light, horn.
This wire is sending an electrical signal to trigger power supply for 5 Red positive (+) output leads.
Positive(+) power lead (Input)- Red wire (47cm/18 ½”)- connect to the positive point on the battery from the bike.
Ground(-) (Input)- Black wire (47cm/18 ½”)- connect to a ground point on battery or frame of the bike.
Positive(+) power lead (output)- Red wire (33cm/13”)- connect to the positive lead of the device.
Ground(-) (output)- Black wire (33cm/13”)- connect to the ground lead of all devices.
LED Indicators and Power On/Off Delay
Once the ignition is turned on/off, the connected devices/accessories will power up/off after a 10-second delay. This is to avoid power supply to devices dropping down when the engine starts/stops.
Red LED light up, the device is failed.
Blue LED flash, 10 seconds power supply delay.
Blue LED solid on, power supply.
Electric Current : Input/Output
Input, the maximum input is 40A
Output, each wire has 5A inline fuse, that can be changed as need, but no more than 15A per line, total maximum current for 5 wires no more than 40A.
5 x Posi-lock for 5 x red positive(+) power lead (
1 x Posi-tap for yellow Ignition trigger wire (145cm/57”) connect to
1 x Spade terminal connector for red positive(+) power lead (Input, 47cm/18 ½”) to connect to the positive
1 x Spade terminal connector for Black wire (47cm/18 ½”) connect to
1 x Spade terminal connector for Black wire (33cm/13”)- connect to the ground lead of all devices.
BUY YOUR INNOVV POWERHUB 1 TODAY WITH ABSOLUTE CONFIDENCE
UK Stock Ready for Fast Delivery. UK Point of contact for support